Omnitub Solo Plus With 8 Jet Whirlpool System

Omnitub Solo Plus With 8 Jet Whirlpool System


Omnitub Solo Plus

The Solo Plus measures 1240 x 740 x 600.

Slightly longer than the original Omnitub Solo, ideal for those long relaxing soaks that you dream about.

Step into a Omnitub Solo Plus and immerse yourself fully, the water keeps hotter longer than a normal bath so you can indulge and relax until your hearts content, and its as easy to install as a conventional bath.

Enjoy and indulge in the deep water unlike any other standard bath.

Delivered with pre-drilled waste and overflow holes.  But no tap holes, to allow variation of the tap location or a bath filler can be used.

8 Jet Whirlpool

4 large jets with directional eyeballs positioned on each side of the bath this can be added to either the Duo or the Solo.


Please note that all Omnitub orders that include a whirlpool system require a 14 day shipping period.

Add To Cart

Care and Installation

Please read these instructions completely before installing your Omnitub.

Inspect your carton for damage before removing the Omnitub.

The Omnitub can be damaged if tools or fittings are dropped into it during installation. It is best to cover the tub with an old blanket or thick cloth during installation when ever possible.

Do not stand in the Omnitub without it being supported on a load bearing structure. If installing an Omnitub Duo you should check the flooring can take the loading without reinforcement.

An Omnitub Duo fully filled with water could apply a load of 400kg/ sqm. This is about the same loading as a full traditional cast iron bath would exert.

Place the bath down on a suitably soft surface so as not to damage the surface of the bath.

You can use the cardboard packaging sleeve to protect the surface.

Adjust the feet until the bath its level and at the correct height.

Place the level on the rim of the bath.

Secure the nuts to the feet.

For safety reasons an overflow should be fitted. If connected to the trap, an ‘extended’ waste & overflow pipe will be needed as the tub is deeper than a standard bath.

Omnitub stock extended wastes in chrome.

Details are on the website: If tap holes are required, holes in the fibreglass should be cut with a tank cutter not a brace and bit.

Masking tape should be used to prevent the fibreglass splintering.

Care Of The Tub

To clean the tub, please use non-abrasive cleaners (ie) liquid cleaners and a non-scratch scourer.  Surface scratches can be removed with T Cut polish.

Unlike acrylic, fibreglass can be buffed up with an electric polisher to regain high gloss if required.