Omnitub Solo Plus
Omnitub Solo Plus
From 26/12/17 to 31/01/18 use code GIVEME15 at checkout to get 15% off of this Omnitub.
The Solo Plus measures 1240 x 740 x 600.
Slightly longer than the original Omnitub Solo, ideal for those long relaxing soaks that you dream about.
Step into a Omnitub Solo Plus and immerse yourself fully, the water keeps hotter longer than a normal bath so you can indulge and relax until your hearts content, and its as easy to install as a conventional bath.
Enjoy and indulge in the deep water unlike any other standard bath.
Delivered with pre-drilled waste and overflow holes. But no tap holes, to allow variation of the tap location or a bath filler can be used.
Total Capacity (Tubs Filled To The Overflow Hole)
Fillings to give immersion with water up to just below the shoulders when seated:
One Person Weighing 80kg | 184 Liters
Weight of Empty Tub
Care and Installation
Please read these instructions completely before installing your Omnitub.
Inspect your carton for damage before removing the Omnitub.
The Omnitub can be damaged if tools or fittings are dropped into it during installation. It is best to cover the tub with an old blanket or thick cloth during installation when ever possible.
Do not stand in the Omnitub without it being supported on a load bearing structure. If installing an Omnitub Duo you should check the flooring can take the loading without reinforcement.
An Omnitub Duo fully filled with water could apply a load of 400kg/ sqm. This is about the same loading as a full traditional cast iron bath would exert.
Place the bath down on a suitably soft surface so as not to damage the surface of the bath.
You can use the cardboard packaging sleeve to protect the surface.
Adjust the feet until the bath its level and at the correct height.
Place the level on the rim of the bath.
Secure the nuts to the feet.
For safety reasons an overﬂow should be ﬁtted. If connected to the trap, an ‘extended’ waste & overﬂow pipe will be needed as the tub is deeper than a standard bath.
Omnitub stock extended wastes in chrome.
Details are on the website: www.omnitub.co.uk If tap holes are required, holes in the ﬁbreglass should be cut with a tank cutter not a brace and bit.
Masking tape should be used to prevent the ﬁbreglass splintering.
Care Of The Tub
To clean the tub, please use non-abrasive cleaners (ie) liquid cleaners and a non-scratch scourer. Surface scratches can be removed with T Cut polish.
Unlike acrylic, fibreglass can be buffed up with an electric polisher to regain high gloss if required.