Omnitub Duo Plus With 12 Jet Whirlpool System

Omnitub Duo Plus With 12 Jet Whirlpool System


Use Code JAN15OFF At Checkout For 15% Off Until 31/01/17

Omnitub Duo Plus

The Duo Plus measures 1250 x 1050 x 600

The Omnitub Duo Plus, slightly longer than the Duo, ideal for sharing with your loved one, immerse yourselves fully in the tub and enjoy and indulge in the Duo Plus's deep water unlike any other standard bath.

As with all our tubs, its shorter and deeper than a standard bath so the water stays hotter for longer, and as easy to fit as a standard bath.

Ideal for those long relaxing soaks that you dream about.

It comes delivered with pre-drilled waste and overflow holes.  No tap holes are pre-drilled to allow variation on the location of the taps or a bath filler can be used.

12 Jet Whirlpool System

3 large jets with directional eyeballs positioned on each side of the bath.

4 mini jets for back massage
2 mini jets for foot massage

This system can be added to both the Duo and Solo Omnitubs


Please note that all Omnitub orders that include a whirlpool system require a 14 day shipping period.

Add To Cart

Care and Installation

Please read these instructions completely before installing your Omnitub.

Inspect your carton for damage before removing the Omnitub.

The Omnitub can be damaged if tools or fittings are dropped into it during installation. It is best to cover the tub with an old blanket or thick cloth during installation when ever possible.

Do not stand in the Omnitub without it being supported on a load bearing structure. If installing an Omnitub Duo you should check the flooring can take the loading without reinforcement.

An Omnitub Duo fully filled with water could apply a load of 400kg/ sqm. This is about the same loading as a full traditional cast iron bath would exert.

Place the bath down on a suitably soft surface so as not to damage the surface of the bath.

You can use the cardboard packaging sleeve to protect the surface.

Adjust the feet until the bath its level and at the correct height.

Place the level on the rim of the bath.

Secure the nuts to the feet.

For safety reasons an overflow should be fitted. If connected to the trap, an ‘extended’ waste & overflow pipe will be needed as the tub is deeper than a standard bath.

Omnitub stock extended wastes in chrome.

Details are on the website: If tap holes are required, holes in the fibreglass should be cut with a tank cutter not a brace and bit.

Masking tape should be used to prevent the fibreglass splintering.

Care Of The Tub

To clean the tub, please use non-abrasive cleaners (ie) liquid cleaners and a non-scratch scourer.  Surface scratches can be removed with T Cut polish.

Unlike acrylic, fibreglass can be buffed up with an electric polisher to regain high gloss if required.